Setting up 1207

Setting up Athena 12.0.6

First time

The following needs to be done only once:

• source /data/atlas/offline/12.0.6/CMT/v1r19/mgr/setup.csh
• mkdir ~/cmthome
  You need this, since you're going to use a customised requirements file
• create the file ~/cmthome/requirements with the following contents:

set CMTSITE STANDALONE
set SITEROOT /data/atlas/offline/12.0.6

macro ATLAS_DIST_AREA ${SITEROOT}
macro ATLAS_TEST_AREA /project/atlas/users/<username>
macro ATLAS_GROUP_AREA /data/atlas/offline/EVGroupArea

apply_tag projectArea
macro SITE_PROJECT_AREA ${SITEROOT}
macro EXTERNAL_PROJECT_AREA ${SITEROOT}

apply_tag setup
apply_tag simpleTest

use AtlasLogin AtlasLogin-* $(ATLAS_DIST_AREA)

set CMTCONFIG i686-slc3-gcc323-opt
set DBRELEASE_INSTALLED  3.1.1

Note: ATLAS_TEST_AREA should be modified (without the '12.0.6'), the ATLAS_GROUP_AREA is needed for TopView

• in the ~/cmthome directory do cmt config
• create a file ~/init1206.csh which contains:

  #! /bin/csh
  # 1 -- setup Athena 12.0.6
  source ~/cmthome/setup.csh -tag=12.0.6,groupArea
  
  # 2 -- setup working area
  setenv CMTPATH /project/atlas/users/<username>/12.0.6:${CMTPATH}
  cd /project/atlas/users/<username>/12.0.6
  

  It will be used everytime you start a new session.
  

  Note: CMTPATH should be modified. The 'groupArea' tag is needed for TopView

Everytime

When you start a new shell you should:

• source ~/init1206.csh
  

Setting up TopView

In your 12.0.6 working area (e.g. /project/atlas/users/<username>/12.0.6 ) do:

klog.krb -tmp -cell cern.ch -principal <afs accountname>
cmt co -r TopView-00-12-12 PhysicsAnalysis/TopPhys/TopView

After the TopView code has been checked out go to the TopView/cmt directory compile the code:

cmt config
source setup.csh
gmake

That's it!

Note: The file LocalOverride.py in TopView/run can be used to create customised TopView ntuples

Links

• To set up Athena at LXPLUS check WorkBookSetAccount < Atlas < Twiki
• For details on TopView see TopView < Atlas < TWiki