Upgrade/VeloModules

Under construction

Communication

• This wiki: https://wiki.nikhef.nl/lhcb/Upgrade/VeloModules
• ELOG: https://webapps.nikhef.nl/elog/VELO_Upgrade_Cooling_VELOpix/
• Progress reports in MT meetings: http://www.nikhef.nl/pub/experiments/bfys/lhcb/vertex/documents/minutes/
• OPP reports: http://www.nikhef.nl/pub/experiments/bfys/lhcb/vertex/documents/oppreports/VeloUpgradeModules/
• LHCb Velo upgrade web page: https://lbtwiki.cern.ch/bin/view/VELO/VELOUpgrade
• photographs:
  • http://www.nikhef.nl/pub/departments/mt/projects/lhcb-vertex/production/

Documentation

• project plans: 2016
• timeline (gantt chart): 2016

Setup for module production QA (last update 22/9/2016)

There are two tests:

1. quick electrical test ("20 seconds"), mainly to check that wirebonds are ok. This test should take place in the clean-room. For this we need:

• LV (incl. PC for controls?)
• DAQ
• fibres to connect to DAQ
• database to summarize results

2. burn-in test ("24 hours"). For this we need:

• LV
• HV (till 1000V; must have precise current control/monitor )
• PC with PVSS to control LV and HV
• DAQ
• fibres to connect to DAQ
• PC to run data analysis (needs to happen in real time as data volumes are very large)
• database to summarize results
• 19 inch rack
• CO2 cooling
• vacuum tank
• if not in the cleanroom, a 'tent' to protect setup

Rough schedule:

• Q4 2016: prepare vacuum tank, cooling
• Q1 2017: prepare DAQ

Action list: