Difference between revisions of "Upgrade/VeloModules"
Jump to navigation
Jump to search
| Line 35: | Line 35: | ||
* PC to run data analysis (needs to happen in real time as data volumes are very large) | * PC to run data analysis (needs to happen in real time as data volumes are very large) | ||
* database to summarize results | * database to summarize results | ||
| − | * | + | * 19 inch rack |
* CO2 cooling | * CO2 cooling | ||
* vacuum tank | * vacuum tank | ||
Revision as of 09:35, 22 September 2016
Under construction
Communication
- This wiki: https://wiki.nikhef.nl/lhcb/Upgrade/VeloModules
- ELOG: https://webapps.nikhef.nl/elog/VELO_Upgrade_Cooling_VELOpix/
- Progress reports in MT meetings: http://www.nikhef.nl/pub/experiments/bfys/lhcb/vertex/documents/minutes/
- OPP reports: http://www.nikhef.nl/pub/experiments/bfys/lhcb/vertex/documents/oppreports/VeloUpgradeModules/
- LHCb Velo upgrade web page: https://lbtwiki.cern.ch/bin/view/VELO/VELOUpgrade
- photographs:
Documentation
Setup for module production QA (last update 21/9/2016)
There are two tests:
1. quick electrical test ("20 seconds"), mainly to check that wirebonds are ok. This test should take place in the clean-room. For this we need:
- LV (incl. PC for controls?)
- DAQ
- fibres to connect to DAQ
- database to summarize results
2. burn-in test ("24 hours"). For this we need:
- LV
- HV (till 1000V; must have precise current control/monitor )
- PC with PVSS to control LV and HV
- DAQ
- fibres to connect to DAQ
- PC to run data analysis (needs to happen in real time as data volumes are very large)
- database to summarize results
- 19 inch rack
- CO2 cooling
- vacuum tank
- if not in the cleanroom, a 'tent' to protect setup
Rough schedule:
- Q4 2016: prepare vacuum tank, cooling
- Q1 2017: prepare DAQ
Action list: