Managing RAID Controllers

From PDP/Grid Wiki
Revision as of 15:18, 4 September 2014 by Dennisvd@nikhef.nl (talk | contribs) (Created page with "Most systems come equipped with a hardware RAID controller, which can be controlled from the OS when the right software is installed. There are a couple of flavours available,...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

Most systems come equipped with a hardware RAID controller, which can be controlled from the OS when the right software is installed. There are a couple of flavours available, the one you need is not always obvious. The software can be used to destroy the RAID set, but more usefully it can be used to:

  • manage the audible alarm (e.g. in case the backup battery unit is failing)
  • blink the led of a disk that needs replacement
  • enable/disable a disk

Installing the software

If it is not already installed, the software is available through the nikhef-external repo with yum. Use either of:

yum install MegaCli
yum install storcli
yum install MegaRAID_Software_Manager

MegaCli is a command-line tool with a rather painful syntax. Storcli is nicer.

/opt/MegaRAID/MegaCli/MegaCli64 -CfgDsply -aALL
/opt/MegaRAID/storcli/storcli64 show all

In case these tools report no RAID controllers, try the StorCli from the last one:

/usr/local/MegaRAID\ Storage\ Manager/StorCLI/storcli64 show all

One of these should work.