HOWTO set up gLExec on the worker node

From PDP/Grid Wiki
Jump to navigationJump to search

This guide will help you make a choice in deployment and configuration for gLExec on the worker node on your site.


Prerequisites

Prerequisite is that you already have a Grid site, including a Compute Element (LCG-CE and/or CREAM-CE) and worker nodes. For more general guidelines for site setup and configuration, see the gLite documentation.

See also the gLite release notes and the Installation Guide.

Central authorization service

It is recommended to set up a central authorization service, either

  • Argus, which is the recommended solution (but see the checklist below), or
  • SCAS, in some special cases

Both options are fully supported, YAIM configurable and offer similar functionality.

Special cases

Check if any of the following apply.

my site makes use of third party plug-ins for LCMAPS
You could still try to set up gLExec for Argus, and use the plug-in from gLExec. If the plug-in should be run centrally, install SCAS instead.
My site uses the LDAP enforcement plug-in for LCMAPS
Set up gLExec with SCAS, and configure SCAS to use the ldap_enf plug-in.
Users are authorised through secondary group mappings
As Argus doesn't support secondary group mappings, install gLExec with SCAS instead.
I need a site-wide centralized authorization service, for the CEs as well as the WNs
The tested option in this case is SCAS, but Argus should work as well; configure CREAM for use with SCAS.
I've tried Argus and I found a problem
Report a bug on Argus; if the problem is a show stopper, try SCAS as a (temporary) alternative.