Difference between revisions of "Daily update"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
===20 February 2017=== | ===20 February 2017=== | ||
| + | ==Links== | ||
| + | * [http://www.nikhef.nl/pub/departments/mt/projects/AliceUpgrade/] Mechanical department ALICE ITS documentation | ||
| + | * [http://cds.cern.ch/record/1625842?ln=en] ALICE ITS upgrade TDR | ||
| + | * [http://sunba2.ba.infn.it/MOSAIC/] MOSAIC firmware and library | ||
| + | |||
==Status== | ==Status== | ||
* <p>straight knife measured to be bent with deviations up to 20 microns</p> | * <p>straight knife measured to be bent with deviations up to 20 microns</p> | ||
Revision as of 19:34, 20 February 2017
20 February 2017
Links
- [1] Mechanical department ALICE ITS documentation
- [2] ALICE ITS upgrade TDR
- [3] MOSAIC firmware and library
Status
straight knife measured to be bent with deviations up to 20 microns
cutting wheel quite possibly damaged
attempted cutting of module with silicon removed showed that the module is not immobile during cutting
movement in 10s of microns while cutting observed (could be solved with new/better knife and wheel)
Discussed
status after last weeks cutting
immediate steps needed for next cutting
update on sensors for the transport box
ToDo:
- repair knife and wheel (Gerrit)
- measure friction due to vacuum (Marco, GS)
- try to remove 2 silicon chips for future cutting simulations (GS)
- measure module movement with deeper wheel bite and/or smaller cut angle (Paul, GS)
- decide on the position of the sensors in the transport box (Paul, Marco)
- install sensors (carpenter?)
- measure environmental effects and shock on the transport box (Marco, GS)